'Bottle Opener' simulation project by jtex4


#1

I created a new simulation project called 'Bottle Opener':

Simple bottle opener. Wanting to 3d print.


More of my public projects can be found here.


#2

A “life-saving” simulation I would say @jtex4 :wink:

Good job! Let me know if you have any questions!

Jousef


#3

Hopefully I did it correctly! Any thoughts or constructive criticism? Very new to all of this and trying to teach myself. Just trying to see if this is structurally good enough of a design to print with polylactic acid.

Thanks!


#4

Hi @jtex4!

Maybe increase the radii in the critical regions and see how that affects the stresses. Also make sure that you do not use 90° corners or sharp edges as this might cause singularity issues and very high stresses. Another point might be to increase the leverage (if necessary) but that’s nothing too important :stuck_out_tongue:

Best,

Jousef